In short
- Best for a small number of specific materials: an Artex ceiling, old floor tiles, a garage roof, a board behind a heater.
- You cannot tell whether a material contains asbestos by looking at it. Only laboratory analysis confirms it.
- Prices start from around £30 per sample plus VAT at some firms for analysis; a visit to take samples costs more.
- If you are planning wider building work, a refurbishment survey is usually better value.
When testing is the right choice
Sample testing suits a narrow question: "does this material contain asbestos?" Common examples around Guildford homes:
- An Artex or textured ceiling you want to skim, scrape or take down.
- Vinyl or thermoplastic floor tiles under a carpet you are lifting.
- A corrugated garage or shed roof.
- A board around a boiler, behind a storage heater, on a door or as a bath panel.
- A cold water tank in the loft or an old flue pipe.
If the job is bigger than that, the material you test is rarely the only one the builders will hit. A targeted refurbishment survey costs more than one sample but covers everything in the work area.
How a professional sample is taken
- The material is wetted or sprayed with a suppressant to stop fibres being released.
- A small piece is removed with hand tools, not power tools.
- The sample is double-bagged and labelled.
- The sample point is sealed with a suitable sealant or tape.
- The sample goes to a laboratory accredited by UKAS for asbestos identification, which examines it under polarised light microscopy and reports whether asbestos was detected and which type.
Reading the result
A positive result tells you the asbestos type: chrysotile (white), amosite (brown) or crocidolite (blue) are the common ones in UK buildings. It does not tell you the risk on its own: a well-sealed cement roof and a damaged insulation board are very different. The firm should explain what the result means for what you were planning, and whether the work is licensed or non-licensed.
Costs
Analysis at one firm starts from about £30 per sample plus VAT. Having someone visit to take samples adds a call-out charge; a few samples taken on a single visit are usually priced as a small job. See the survey cost guide for how this compares with a full survey.
Questions people ask
Can I take the sample myself?
Home testing kits exist and some people use them for a single material in their own home. HSE advises that sampling is done by a competent person. Taking a sample disturbs the material, so if you do it yourself, wet it, wear suitable disposable protection, seal the sample and the sample point, and never sample materials that are soft, crumbly or lagging.
How long do results take?
Laboratories commonly turn standard samples around in a few working days, with faster options for a fee. Ask the firm when booking.
What does a negative result mean?
That asbestos was not detected in that sample. It does not prove the same material elsewhere in the building is free of asbestos, especially if it was applied at different times.
Is a sample test enough before renovation?
Only if the work truly involves just the materials tested. Most renovations disturb more than you expect, which is why a refurbishment survey of the work area is the usual requirement.