In short
- The most common finds in homes are textured coatings, vinyl floor tiles and asbestos cement (garage roofs, soffits, gutters, flues, water tanks).
- Higher-risk materials such as insulating board and pipe lagging turn up less often, typically around boilers, heaters and airing cupboards.
- Asbestos in good condition and left alone is low risk. Problems start when it is drilled, cut, sanded or broken.
- Before work in a pre-2000 house, get the work area checked.
Inside the house
| Where | Material | Typical risk if disturbed |
|---|---|---|
| Ceilings and walls | Textured decorative coatings such as Artex | Lower: bonded, low asbestos content |
| Floors | Vinyl or thermoplastic floor tiles, and the black bitumen adhesive under them | Lower |
| Around the boiler, in the airing cupboard | Asbestos insulating board (AIB), lagging on pipes and cylinders | Higher: licensable in most cases |
| Behind fires and storage heaters | Insulating board panels, rope seals | Higher for board |
| Partition walls, boxing, panels above doors and windows | Insulating board | Higher |
| Bathrooms | Bath panels, cisterns and toilet seats in some older moulded types | Lower to medium |
| Under sinks | Sound-deadening pads | Lower |
| Fuse boxes | Board behind or inside older fuse boxes, fuse carriers | Medium |
| Loft | Cement water tanks; occasionally loose-fill insulation | Tanks lower; loose fill very high |
Outside the house
| Where | Material |
|---|---|
| Garage and shed roofs, wall panels | Asbestos cement sheet |
| Soffits and fascias | Asbestos cement or insulating board |
| Gutters and downpipes | Asbestos cement |
| Flue pipes | Asbestos cement |
| Panels below windows | Asbestos cement or insulating board |
| Roof felt and some older roof tiles | Bitumen products or fibre cement |
This list follows the common locations shown in HSE's guidance on asbestos in buildings and council housing guides. Not every house has all of them; most have a few.
Why the type matters
Asbestos cement, textured coatings and floor tiles hold the fibres tightly in a matrix. They release relatively few fibres unless broken up or abraded. Insulating board, lagging and sprayed coatings are softer and release fibres far more easily, which is why most work on them is licensed.
What to do
- Leave it alone if it is in good condition and you are not about to work on it.
- Test it if you are planning to work on one specific material. See asbestos testing.
- Survey the work area before renovation. See refurbishment surveys.
- Stop and check if something has been damaged. See what to do if you disturb asbestos.
Questions people ask
Do all houses built before 2000 have asbestos?
No, but many do, and you cannot rule it out without checking. Houses built after 2000 are unlikely to contain it.
Is asbestos in my loft insulation?
Modern mineral wool loft insulation does not contain asbestos. Loose, grey or brown granular or fluffy insulation in older lofts can occasionally be loose-fill asbestos or vermiculite that may be contaminated. Do not disturb it; get it tested.
Should I remove asbestos from my house as a precaution?
Not usually. Removal itself disturbs the material. If it is in good condition and you are not doing work that would disturb it, leaving it and knowing where it is is often the safest option.