In short
- Treat any textured ceiling or wall coating applied before 2000 as possibly containing asbestos until tested.
- Reported HSE figures put chrysotile content at about 3.8% in trade powder Artex and 1.8% in ready-mixed DIY Artex.
- In good condition it can be left and painted. Do not sand, scrape, drill or steam it without testing first.
- A single sample test is the cheapest way to know.
Why Artex contained asbestos
Artex is a brand name that became a generic term for textured decorative coatings on ceilings and walls: swirls, stipples, fans and bark effects. White asbestos (chrysotile) was added to strengthen the coating. Industry sources commonly put the switch to asbestos-free formulations in the mid-1980s, but older stock and other brands continued in use, and white asbestos was not banned in the UK until 1999.
Figures reported from an HSE committee paper (WATCH/2006/1) put the chrysotile content at about 3.8% by weight in trade powder products and about 1.8% in ready-mixed DIY products. That is low compared with insulation products, which is why the material is not usually licensable, but it is still asbestos.
How to tell if yours contains asbestos
You cannot tell from the pattern or colour. Asbestos and asbestos-free coatings look identical. The options are:
- Sample test. A small sample is taken, the spot sealed and the sample analysed by an accredited laboratory. See asbestos testing.
- Survey. If you are renovating more than one room, a refurbishment survey covers the Artex along with everything else in the work area.
- Presume. You can treat it as asbestos without testing. That is the safe default if you are not going to touch it.
Your options
| Option | When it suits | Watch out for |
|---|---|---|
| Leave it and paint | Coating in good condition, no work planned | Do not sand or scrape first |
| Skim over it | You want a smooth ceiling, coating is sound | Knocking off peaks disturbs it; test first |
| Board over it | Ceiling uneven or cracked | Screws go through the coating; minimise and control |
| Remove it | Renovation, damage, or a negative test | Must be done by a trained contractor if positive |
Things not to do
Do not dry-sand, power-scrape, wire-brush or use a steam stripper on a coating that might contain asbestos, and do not let a decorator or plasterer do so without a test result. These methods create fine dust that spreads through the house and is hard to clean.
If you have already disturbed it
Stop, keep people and pets out of the room, close the door and do not vacuum with a household vacuum. Read what to do if you disturb asbestos.
Questions people ask
Can I paint over Artex that might contain asbestos?
Yes. Painting with emulsion does not disturb the coating and helps seal it. Avoid sanding or scraping first.
Can I plaster (skim) over asbestos Artex?
Skimming over a sound coating is a common way of covering it, because the asbestos stays sealed beneath. The risk comes from knocking off the peaks or sanding before plastering, so test first and tell the plasterer the result.
Is it safe to drill a hole for a light fitting?
A single small hole in a coating that might contain asbestos should be done with care: wet the area, use a hand drill or a drill with shadow vacuum, and clean up with damp wipes. Better still, test it first.
Who can remove asbestos Artex?
Removing textured coatings is usually non-licensed work, but it needs a trained contractor with suitable controls, and depending on method and condition it may be notifiable non-licensed work. It is not a DIY job.